He turns the ignition key on your mid-90's Ford car and you'll get a click. First, it is thought that the battery is low or the battery cables are not protected. You will be surprised that the problem with the small red wire, whose start-up (located at the top of the starter attached).
Ford products (Ford, Lincoln, Mercury) in 1992-2006 had a design flaw in the starter, which often causes a no start, no crank condition.The problem is connecting the terminal to start the ignition solenoid valve was returned. Ford finally with a conversion kit that corrects the problem. E '6U2Z Ford part number-14S411-NA in the Technical Service Bulletin 06-19-14 discussed October 2, 2006.
Jump Starter
The connection terminal on the solenoid power is the smaller of the two electrical connections to the starter. It is usually red and binds to the solenoid during a push-pull-off called on the connection of a male spadeName. This compound is the primary source of teething problems, as corrodes easily, so the connection fails.
The Ford Motor Company has a conversion kit that converts the connection type fork made a loop / post-type connection. That will solve the problem. Another alternative is the complete set of starting with a new one or has reconstructed the latest compound, which is built the way forward, I recommend to replace.
Replacing the starteris a simple task. There are only two screws holding the starter in place. Then there is a nut on the battery, the cable must be removed to remove the 'power. Finally, there is a smaller wire, which must be separated from the valve solenoid.
Disconnect the negative battery cable before you restore an appetizer (or alternator, etc.).
Do not buy a replacement or a starter of time, which connect to the male range is used, as the eldestType of connection starts causing problems in less than a year.
Starter solve problems on the 1992 - 2006 Ford productsbicycle tire sizes chart dual suspension mountain bikes vinyl wall quotes
No comments:
Post a Comment